Set of cutters "Profi"

Set of cutters "Profi"
This set consists of high-quality cutters that are used for finishing and roughing, and are suitable for engraving thin inscriptions, patterns, flares, processing 3D reliefs, bas-reliefs, shapes, cutting along the contour, leveling the surface, selections, recesses, processing deep grooves.
With this kit you can work on plastics, wood, plywood, fiberboard, MDF, plexiglass, acrylic, composite, plastic, veneer and soft non-ferrous metals.
The set is accompanied by a table of the ratio of material and type of cutter, a description of cutting conditions, general recommendations.
What cutters are included in this kit:
1. Taper cutter HRC55*R0.75*60C*6D*100L – 1 piece (3d processing)
2. Taper cutter HRC55*R1*47C*8D*100L – 1 piece (3d processing)
3. Spherical end mill R3*D6*32C*60L – 1 piece (finishing and roughing)
4. Spherical end mill R2*D4*8C*50L – 1 piece (finishing and roughing)
5. End cutter D4*10C*50L*4f - 1 pc. (roughing, trimming, cutting)
6. End cutter D6*25C*100L*4f - 1 pc. (roughing, trimming, cutting)
7. Cutter corn D4*22C*45L - 1 pc. (cut such materials as: plywood, textolite, plastic, fiberglass)
8. Cutter corn D3.175*3.175*17*38 - 1 pc. (cut such materials as: plywood, textolite, plastic, fiberglass)
9. Single-thread cutter D6*25*50 - 1 pc. (cutting, cutting, milling of different materials)
10. Single-thread cutter D3,175*12C*45L - 1 pc. (cutting, cutting, milling of different materials)
11. Single start cutter D4*22C*45L - 1 pc. (cutting, cutting, milling of different materials)
12. Cutter with straight blades D4*25C*45L - 1 pc. (cut plywood, PVC, MDF, chipboard).
13. Cutter with straight blades 6 * 6 * 25 * 50 - 1 pc. (cut plywood, PVC, MDF, chipboard).
14. Chipbreaker 10*25*75 - 3f (roughing different materials)
15. Engraver pyramid 3.175 * 0.1 * 60 ° (for processing 2D-3D small elements)
16. Conical engraver with a straight shelf W0.2 D3.175 45° (for thin inscriptions and patterns, cliches, small 2D - 3D relief elements).
 
Kit contents may change.